Start from the two numbers that matter
In almost every PC the processor and graphics card account for most of the power. Both makers publish the figure you need. Intel's spec pages list a Processor Base Power and a Maximum Turbo Power: the Core i5-14400 is 65 W base and 148 W maximum, the Core i7-14700K is 125 W and 253 W. Size for the maximum, because that is what the chip will pull during a long export or compile.
For graphics cards, NVIDIA lists Total Graphics Power and a Required System Power: the RTX 4060 is 115 W and 550 W, the RTX 5070 is 250 W and 650 W. NVIDIA notes its 50-series figure assumes a PC built around a Ryzen 9 9950X, so a hungrier CPU can push the real need above the card maker's number. AMD's processor pages list a “Default TDP”, which boost behaviour can exceed; if you have a measured package power from a monitoring tool or a review, use that instead.
Headroom, efficiency and 230 V
A power supply is most efficient around half load. The 80 PLUS programme run by CLEAResult certifies separate minimums for 230 V mains, which is what India uses. For a Gold unit on 230 V the minimums are 90% at 20% load, 92% at 50% and 89% at 100%; for Bronze, 85%, 88% and 85%. That is why the calculator adds 30% headroom by default: full load sits near 75% of the rating, the supply runs cooler and quieter, and there is margin as capacitors age.
Going much bigger than needed buys little. A supply only draws what the PC uses; an oversized unit spends most of its life at light load, where efficiency is slightly lower. The difference between Bronze and Gold is also smaller than marketing implies: for a 400 W load run 8 hours a day, 300 days a year, the 50%-load minimums (88% vs 92%) differ by about 20 W at the wall — roughly 47 units a year, or under ₹400 at ₹8 a unit. Buy Gold for heat and noise; buy quality for reliability.
Transient spikes, ATX 3.x and the 12V-2x6 connector
Modern graphics cards draw very short power spikes far above their rated board power. Older supplies could see these as an overload and shut the PC off mid-game, even though the average load was well within rating. Intel's ATX 3 power supply design guide now defines how much excursion a supply must ride through: a unit above 450 W with a 12V-2x6 connector must handle 200% of its rated power for 100 microseconds, 180% for 1 ms, 160% for 10 ms and 120% for 100 ms. Supplies of 450 W or less, or without that connector, are tested at 150%, 145%, 135% and 110%.
In practice: a 750 W ATX 3.x unit is designed to carry 1,500 W for a tenth of a millisecond. For a card that uses the 12VHPWR / 12V-2x6 connector, use a supply with a native cable rather than an adapter, and NVIDIA recommends a PCIe CEM 5.1-compliant supply for its 50-series cards. Wattage headroom alone is not a substitute for a supply designed for these spikes.
Two builds worked through
An office PC on a Core i5-14400 with integrated graphics: 148 + 0 + 50 + 10 + 15 = 223 W at full load, 300 W recommended with 30% headroom. Wattage is not the constraint here. Pick a supply from a known maker with an 80 PLUS certificate you can look up, because cheap units with inflated labels fail at this size too.
A gaming or editing PC on a Core i7-14700K with an RTX 5070: 253 + 250 + 50 + 10 + 15 = 578 W, 800 W recommended — more than NVIDIA's 650 W because we size for Intel's full 253 W turbo figure. At 72% load a Gold unit is about 91% efficient, so the PC pulls around 640 W from the wall at full tilt. That matters for the UPS: an 1100 VA / 660 W line-interactive UPS would be at its limit with the monitor added. Run the UPS backup calculator with the wall figure, not the PSU label.

